Linux - bootp server configuration, Bootp options – Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) User Manual

Page 419

Advertising
background image

Brocade Mobility 5181 Access Point Product Reference Guide

405

53-1002516-01

Configuring Automatic Updates using a DHCP or Linux BootP server

B

Linux - BootP server configuration

See the following sections for information on these BootP server configurations in the Linux
environment:

BootP options

BootP priorities

BootP options

This section contains instructions for the automatic update of the access point firmware and
configuration file using a BootP Server.

The setup example described in this section includes:

1

Mobility 5181 Access Point

model access point

1 Linux/Unix BOOTP Server

1 TFTP Server.

To configure BootP options using a Linux/Unix BootP Server:

1. Set the Linux/Unix BootP Server and access point on the same Ethernet segment.

2. Configure the bootptab file (/etc/bootptab) on the Linux/Unix BootP Server in any one of the

formats that follows:

Using options 186, 187 and 188:

Using options 66, 67 and 129:

Using options sa, bf and 136:

:h a = 0 0 a 0 f8 8 a a 6 d 8 \ < L A N M A C A d d re s s >

:s m = 2 5 5 .2 5 5 .2 5 5 .0 \ < S u b n e t M a s k >

:ip = 1 5 7 .2 3 5 .9 3 .1 2 8 \ < IP A d d re s s >

:g w = 1 5 7 .2 3 5 .9 3 .2 \ < g a te w a y >

:T 1 8 6 = ” 1 5 7 .2 3 5 .9 3 .2 5 0 ” \ < T F T P S e rv e r IP >

:T 1 8 7 = "a p fw .b in "\ < F irm w a re file >

:T 1 8 8 = "c fg .tx t": < C o n fig u ra tio n file >

1 :h a = 0 0 a 0 f8 8 a a 6 d 8 \ < L A N M A C A d d re s s >

:s m = 2 5 5 .2 5 5 .2 5 5 .0 \ < S u b n e t M a s k >

:ip = 1 5 7 .2 3 5 .9 3 .1 2 8 \ < IP A d d re s s >

:g w = 1 5 7 .2 3 5 .9 3 .2 \ < g a te w a y >

:T 6 6 = ” 1 5 7 .2 3 5 .9 3 .2 5 0 ” \ < T F T P S e rv e r IP >

:T 6 7 = "a p fw .b in "\ < F irm w a re file >

:T 1 2 9 = "c fg .tx t": < C o n fig u ra tio n file >

Advertising