Operating wmt700, Operating wmt700 with terminal program – Vaisala WMT700 User Manual
Page 128
User's Guide ______________________________________________________________________
Operating WMT700
After WMT700 has been installed and configured, you can start
operating the wind sensor as follows:
- To receive wind measurement data through a serial connection
as data messages, use serial communication.
When using the WMT700 profile, see the operating
instructions below.
For using the WS425 or SDI-12 profiles, see section Operating
WMT700 with WS425 and SDI-12 Profiles
- To receive wind measurement data as current, potentiometer,
voltage, or frequency output, use analog output.
For general information, see section Analog Output on page
50.
For instructions on using WMT700 analog output in a system
configured for WS425, see section Operating WMT700 in
WS425 Analog Output Mode on page 139.
NOTE
For a complete list of the serial commands available for the WMT700
series wind sensors, see Appendix A, Complete Command Set for
WMT700, on page 195.
Operating WMT700 with Terminal
Program
To operate WMT700 through a serial connection, the following
prerequisites are needed:
- PC with a serial port
- Required cables for serial connection. For more information,
see section Cables on page 33.
- Any terminal program, such as Tera Term or Windows
®
HyperTerminal
To switch on WMT700 in the measurement mode using
Windows
®
HyperTerminal, see section Communicating with
Terminal Software on page 107.
For information on operating commands, see section
Measurement Mode Commands on page 135.
For information on available data messages, see section Data
Messages on page 127.
126 __________________________________________________________________ M211095EN-E