Meas — start measurement, Open — enter configuration mode, Table 41 – Vaisala WMT700 User Manual
Page 138: Measurement mode commands
User's Guide ______________________________________________________________________
Table 41
Measurement Mode Commands
Command
Description
$aMEAS
Starts wind measurement in single measurement mode. The
duration of the measurement is based on the user-
configurable averaging time.
$aOPEN
Switches the serial port to configuration mode.
$aPOLL,y
Fetches latest measurement data from WMT700.
$aSLEEP
Switches WMT700 from normal operating mode to low-power
mode.
where
$
=
Fixed text
a
=
WMT700 address. If the value is 0, it refers to any
WMT700 address
y
=
Identification number for the data message format. For a
list of the data message formats, see Table 40 on page 128
MEAS — Start Measurement
This command starts wind measurement in single measurement
mode based on the user-configurable averaging time. WMT700
does not send the data message automatically. Use the polling
command to fetch the measurement data in the required format.
$aMEAS<CR><LF>
where
$
=
Fixed text
a
=
WMT700 address. If the value is 0, it refers to any
WMT700 address
OPEN — Enter Configuration Mode
This command switches the serial port to the configuration mode.
$aOPEN<CR><LF>
where
$
=
Fixed text
a
=
WMT700 address. If the value is 0, it refers to any
WMT700 address
NOTE
WMT700 automatically returns to normal operating mode, if no
commands are received in two minutes, or multiple unrecognized
commands are detected.
136 __________________________________________________________________ M211095EN-E