Vaisala WMT700 - Manual (Page 172)

User's Guide ______________________________________________________________________
aAb! — Change Address
This command changes the WMT700 address. After WMT700
has received this command and sent a response, the sensor does
not respond to any other command for one second. This gives
WMT700 time to write the new address to the non-volatile
memory.
NOTE You can also change the WMT700 address by entering configuration
mode and changing the address parameter.
aAb!
where
a = Current single-digit WMT700 address that corresponds
to the first character of the address value
A = Change address command
b = New address
! = Terminates the command
The response is the following:
b<CR><LF>
where
b = New single-digit WMT700 address (or the original
address if WMT700 is unable to change the address)
<CR><LF> = Terminates the response
170 __________________________________________________________________ M211095EN-E