Figure 34, Bird cage and bird cage straps – Vaisala WMT700 User Manual
Page 78
User's Guide ______________________________________________________________________
To install the optional bird cage:
1.
Unpack the bird cage and the bird cage straps.
2.
Position the bird cage on top of the wind sensor and press
the kit down until the three hooks are in contact with the
transducer arms.
3.
Run the lower strap through the three guides in the kit.
Figure 34 below shows the correct position.
4.
Lift the latch screw.
5.
Insert the strap to the latch.
6.
Press the latch screw down.
7.
Tighten the screw by turning the screw clockwise with a
screw driver or a socket. Do not over-tighten the screw.
8.
Run the upper strap through the three guides in the kit.
9.
Repeat the steps 4-7 for the other strap.
1104-086
Figure 34
Bird Cage and Bird Cage Straps
The following numbers refer to Figure 34 above:
1 = Bird cage
2 = Bird cage straps
3 = Wind sensor
4 = Guide for attaching the straps
5 = Latch for securing the straps
76 ___________________________________________________________________ M211095EN-E