Vaisala WMT700 - Manual (Page 99)

Chapter 4 ________________________________________________________________ Installation
Tightening Connector
When connecting the cable to your WMT700, it is recommended
that you tighten the connector with the cable tightening tool
shipped with your WMT700. The ribbed part of the tool offers a
better grip of the cable when tightening the connector. Insert the
cable in the cable tightening tool as shown in Figure 30 on page
71 and Figure 25 on page 65. You do not need to remove the
cable tightening tool when the connector is tightened.
You can tighten the connector without the cable tightening tool by
rotating the ribbed part of the connector by hand as shown in
Figure 31 on page 72. However, do not use tools when tightening
the connector.
NOTE Verify that the connector is properly tightened to avoid water leakage and
damage to the sensor. If water leaks into the connector, this voids the
warranty for WMT700.
VAISALA ________________________________________________________________________ 97