Vaisala WMT700 - Manual (Page 48)

User's Guide ______________________________________________________________________
Regardless of the factory configuration, COM2 interface type can
be changed by using terminal software. For more information, see
section com2_interf in Appendix D, Configuration Parameters, on
page 205.
For information on wiring, see section Wiring on page 77.
Profiles
The digital communication profile is used to preconfigure
WMT700 according to your order at the factory. Depending on
the preconfigured communication profile, the default settings of
the following parameters may vary:
- Communication protocols
- Communication parameters
See Appendix C, Default Settings for Different Communication
Profiles, on page 201 for the factory defaults for all
communication profiles. The preconfigured communication
profiles are:
- WMT700
- ROSA - MES12
- WS425 - ASCII
- WS425 - NMEA Extended (version 0183)
- WS425 - SDI-12 (version 1.3)
- WS425 – ASOS
The WMT700 profile is recommended for normal operation. The
profile offers a wide range of predefined and user-configurable
data message formats, and it is specifically developed for
WMT700. For information on user-configurable data messages,
see section Parameter Handling Commands on page 111. For
information on predefined data messages, see section Data
Messages on page 127.
The ROSA - MES12 profile is intended for connecting WMT700
to the Vaisala ROSA system.
The WS425 profiles can be used when upgrading from the
WS425 wind sensor to WMT700.
For a list of the serial commands available for all communication
profiles supported by WMT700, see Appendix A, Complete
Command Set for WMT700, on page 195.
46 ___________________________________________________________________ M211095EN-E