Vaisala WMT700 - Manual (Page 141)

Chapter 5 _________________________________________________________________ Operation
Operating WMT700 in WS425 Analog
Output Mode
This section provides information on operating WMT700 in
analog output mode in a system configured for WS425. For
general information on operating WMT700 with analog output,
see section Analog Output on page 50.
Analog Output Settings
In analog output operation WMT700 takes measurements
according to the configured averaging time and synthesizes the
analog outputs of wind speed and wind direction with an update
interval of 0.25 seconds. The analog output signal type and range
depend on the configured settings.
Normally, analog output is enabled and the output settings are
preconfigured at the factory according to your order. WMT700
can be operated using these settings directly after the installation.
However, the analog output settings of WMT700 can be changed
or the analog output functionality can be disabled at any time to
save power over the serial interface.
When operating WMT700 in a system configured for WS425, the
analog output settings must be configured according to Table 42
on page 140 using the S command. For more information on the S
command, see section S — Set Parameter on page 112.
VAISALA _______________________________________________________________________ 139