Allied Telesis AT-S63 - Manual (Page 100)

Chapter 7: File System
100 Section II: Advanced Operations
5. Click the Apply button.
The master switch searches the file system or flash memory card for
the file. If it finds the file, it displays the file name in the Default
Configuration File field along with the word “Exists.” The file is now the
active boot configuration file on the switch.
If the switch can not locate the file, it displays the name of the previous
boot configuration file. Repeat steps 4 and 5, being sure to enter the
name correctly.
6. Do one of the following:
ˆ To configure the stack using the parameter settings in the new
active configuration file, do not select Save Config. Instead, reset
or power cycle the stack.
ˆ Or, to overwrite the settings in the new active configuration file with
the stack’s current settings, click the Save Config button.