Allied Telesis AT-S63 - Manual (Page 166)

Chapter 11: SNMPv3
166 Section III: SNMPv3
4. Click the Add button to display the Add New SNMPv3 Target
Parameter page, shown in Figure 57.
Figure 57. Add New SNMPv3 Target Parameters Page
5. Configure the parameters, described in Table 28, for the new entry
and click the Apply button.
Table 28. SNMPv3 Target Parameters Table Parameters
Parameter Description
Target Parameters Name A name for the entry of up to 32 alphanumeric characters.
Message Processing Model Enter a value for the Message Processing Model field only if
you select SNMPv1 or SNMPv2c as the Security Model. If you
select the SNMPv3 protocol as the Security Model, then the
stack automatically assigns the Message Processing Model to
SNMPv3.
Security Model The Security Model for this Security Name or User Name. The
possible values are
1-v1 - This value associates the Security Name or User Name
with the SNMPv1 protocol.
2-v2c - This value associates the Security Name or User Name
with the SNMPv2c protocol.
3-v3 - This value associates the Security Name or User Name
with the SNMPv3 protocol. The SNMPv3 protocol allows you to
configure the group to authenticate SNMPv3 entities (users)
and to encrypt messages.