Allied Telesis AT-S63 - Manual (Page 162)

Chapter 11: SNMPv3
162 Section III: SNMPv3
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Deleting a Target
Address Table
Entry
To delete an entry from the SNMPv3 Target Address Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 52.
3. In the SNMPv3 section, click the radio button for Configure Target
Address Table and then click the Configure button to display the
SNMPv3 Target Address Table tab, shown in Figure 53 on page 160.
4. Toggle through the entries with the Next and Previous buttons until
the table displays the entry you want to delete.
Retries The number of times the stack retrIes, or resends, an Inform
message. When an Inform message is generated, a response
from the stack is required. This parameter determines how
many times the stack resends an Inform message. The Retries
parameter applies to Inform messages only. The range is 0 to
255 retries. The default is 3 retries.
Tag List The tag or list of tags defined by the Notify Tag parameter in
the corresponding entry in the SNMPv3 Notify Table. The tag
list can be up to 256 alphanumeric characters. Separate
entries with spaces, for example:
hwengtag swengtag testengtag
Target Parameters The corresponding Target Parameters name. This value has to
match the name of the corresponding entry in the SNMPv3
Target Parameters Table.
Storage Type The storage method of the entry. The possible values are:
V-Volatile - This setting prevents the stack from saving the
entry in the master configuration file. An entry with this storage
type is discarded the next time the stack is reset or powered
off.
N-NonVolatile - This setting allows the stack to save the entry
in the master configuration file when the save command is
issued. Allied Telesis recommends this storage type.
Row Status The status of the entry. All entries have a status of Active.
Table 27. SNMPv3 Target Address Table Parameters
Parameter Description