Configuring the snmpv3 securitytogroup table, Creating a securitytogroup table entry, Figure 47: snmpv3 securitytogroup table tab – Allied Telesis AT-S63 User Manual
Page 152
Chapter 11: SNMPv3
152
Section III: SNMPv3
Configuring the SNMPv3 SecurityToGroup Table
To create, delete, or modify SNMPv3 SecurityToGroup Table entries, refer
to the following procedures:
“Creating a SecurityToGroup Table Entry” on page 152
“Deleting a SecurityToGroup Table Entry” on page 154
“Modifying a SecurityToGroup Table Entry” on page 155
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 52.
3. In the SNMPv3 section, click the radio button for the Configure
SecurityToGroup Table and then the Configure button to display the
SNMPv3 SecurityToGroup Table tab in Figure 47.
Figure 47. SNMPv3 SecurityToGroup Table Tab
4. To create an SNMPv3 SecurityToGroup Table entry, click the Add
button to display the Add New SNMPv3 SecurityToGroup page in
Figure 48.