Enabling or disabling snmp management – Allied Telesis AT-S63 User Manual
Page 135
AT-S63 Web Browser User’s Guide for AT-9400 Stacks
Section III: SNMPv3
135
Enabling or Disabling SNMP Management
Before you can manage a stack with SNMP, you have to enable SNMP
access on the stack, as explained in this section. Furthermore, if you want
the stack to send authentication failure traps when there is an
unsuccessful login attempt, you also have to enable authentication failure
traps.
To enable or disable SNMP access and authentication failure traps:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 52.
3. Click the Enable SNMP Access check box to enable or disable SNMP
management. A check in the box indicates that the feature is enabled,
meaning that the stack can be managed from an SNMP management
station. No check indicates that the feature is disabled. The default is
disabled.
Note
If the Enable SNMP Access check box is not checked, the stack
cannot be managed through SNMP.
4. If you want the stack to send authentication failure traps, click the
Enable Authentication Failure Traps check box. A check in the box
indicates that the stack sends the trap.
5. Click the Apply button.
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.