Allied Telesis AT-S63 - Manual (Page 31)

AT-S63 Web Browser User’s Guide for AT-9400 Stacks
Section I: Basic Operations 31
Figure 4. System Utilities Tab
3. Click the Reboot Switch After Resetting to Defaults check box.
4. Click the Apply button.
5. At the confirmation prompt, click the OK button to continue or the
Cancel button to cancel the procedure.
If you select OK, the stack resets and all of the parameters are
returned to the default settings. After the reset is complete, you must
establish a local management session if you want to continue
managing the unit.
As mentioned at the start of this procedure, returning a stack to its
default settings does not alter the contents of the active boot
configuration file. To return the file to the default settings, you must
save the current switch settings after establishing a local management
session with the stack. Otherwise, the stack will return to its previous
parameter settings the next time you reset or power cycle the stack.