Allied Telesis AT-S63 - Manual (Page 170)

Chapter 11: SNMPv3
170 Section III: SNMPv3
Configuring the SNMPv3 Community Table
To create, delete, or modify SNMPv3 Community Table entries, refer to
the following procedures:
ˆ “Creating an SNMPv3 Community Table Entry” on page 170
ˆ “Deleting an SNMPv3 Community Table Entry” on page 172
ˆ “Modifying an SNMPv3 Community Table Entry” on page 172
Note
The SNMPv3 Community Table is used to configure the protocol for
use with SNMPv1 or SNMPv2c. Allied Telesis does not recommend
this configuration.
Creating an
SNMPv3
Community
Table Entry
To create an entry in the SNMPv3 Community Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 52.
3. In the SNMPv3 section, click the radio button for Configure
Community Table and then click the Configure button to display the
SNMPv3 Community Table tab, shown in Figure 59.
Figure 59. SNMPv3 Community Table Tab
4. Click the Add button to display the Add New SNMPv3 Community
page in Figure 60.