Allied Telesis AT-S63 - Manual (Page 23)

AT-S63 Web Browser User’s Guide for AT-9400 Stacks
Section I: Basic Operations 23
Note
This procedure describes the System Name, Administrator, and
Comments parameters in the Administration section of the tab. The
parameters in the IP Configuration section are described in
“Displaying the IP Address of the Local Interface” on page 32. The
Passwords section is described in “Changing the Manager or
Operator Password” on page 24. The Reset button at the bottom of
the tab resets the switch and is explained in “Resetting a Stack” on
page 28.
4. Configure the parameters as needed. The parameters are described in
Table 1.
5. Click the Apply button.
6. To save your changes in the configuration file, click the Save Config
button in the Configuration menu.
Table 1. System Name, Administrator, and Comments Parameters
Parameter Definition
System Name This parameter specifies a name for the
stack (for example, Sales Ethernet stack).
The name is displayed at the top of the
pages and tabs in the management
software. The name can be from 1 to 39
characters. Spaces and special
characters, such as exclamation points
and asterisks, are permitted.
Administrator This parameter specifies the name of the
network administrator responsible for
managing the switch. The name can be
from 1 to 20 characters. Spaces and
special characters are permitted.
Comments This parameter specifies the location of
the switch, (for example, 4th Floor - rm
402B). The location can be from 1 to 20
characters. Spaces and special
characters are permitted.