Allied Telesis AT-S63 - Manual (Page 120)

Chapter 9: Event Logs and the Syslog Client
120 Section II: Advanced Operations
Output Status Sets the status of the syslog output
definition. The options are:
Enabled - The master switch uses the
definition to send the event messages to
the defined syslog server.
Disabled - The master switch does not
use the definition to send event
messages.
Message Format Controls the format of the event
messages. The options are:
Extended - The event messages contain
the time, module, severity, description, file
name, line number, and event ID. This is
the default.
Normal - The event messages contain just
the time, module, severity, and
description.
Severity Selections Specifies the severity of the events to
send to the syslog server. Use Ctrl key to
select more than one severity. The
options are:
ALL - Sends all of the event messages.
This is the default.
Error - Sends just error event messages.
Error messages indicate that the switch
operation is severely impaired.
Warning - Sends only warning event
messages. These messages indicate that
an issue may require manager attention.
Information - Sends only informational
event messages. Informational messages
display useful information that you can
ignore during normal operation.
Debug - Sends debug event messages.
These events provide detailed high-
volume information intended only for
technical support personnel.
Table 18. Syslog Output Definition Parameters
Parameter Definition