Configuring the snmpv3 target parameters table, Creating a target parameters table entry, Figure 56: snmpv3 target parameters table tab – Allied Telesis AT-S63 User Manual
Page 165
AT-S63 Web Browser User’s Guide for AT-9400 Stacks
Section III: SNMPv3
165
Configuring the SNMPv3 Target Parameters Table
Here are the procedures for managing the SNMPv3 Target Parameters
Table:
“Creating a Target Address Table Entry” on page 160
“Deleting a Target Address Table Entry” on page 162
“Modifying a Target Address Table Entry” on page 163
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 52.
3. In the SNMPv3 section, click the radio button for the Configure Target
Parameters Table and then click the Configure button to display the
SNMPv3 Target Parameters Table tab in Figure 56.
Figure 56. SNMPv3 Target Parameters Table Tab