Allied Telesis AT-S63 - Manual (Page 42)

Chapter 2: Port Parameters
42 Section I: Basic Operations
MDI/MDIX Crossover Sets the wiring configuration of a twisted
pair port. The possible settings are:
Auto - Sets the MDI or MDIX setting
automatically. This is the default value.
This setting is only available when a port
is set to Auto-Negotiation.
MDI - Sets a port to MDI. This setting is
only available when a port’s speed and
duplex mode are set manually.
MDIX - Sets a port to MDIX. This setting is
only available when a port’s speed and
duplex mode are set manually.
This parameter does not apply to fiber
optic ports.
Ingress Broadcast Filter Enables or disables the ingress broadcast
filter on a port. Possible settings are:
Enabled - The port discards ingress
broadcast packets.
Disabled - The port forwards ingress
broadcast packets. This is the default
setting.
Egress Broadcast Filter Enables or disables the egress broadcast
filter on a port. Possible settings are:
Enabled - The port discards egress
broadcast packets.
Disabled - The port forwards egress
broadcast packets. This is the default
setting.
Ingress Unknown Unicast
Filter Use this parameter to configure a port to
forward or discard unknown ingress
unicast packets. The possible settings
are:
Enabled - The port discards unknown
ingress unicast packets.
Disabled - The port forwards unknown
ingress unicast packets. This is the
default setting.
Table 5. Port Configuration Window
Parameter Definition