ETC Eos v1.3 - Manual (Page 101)

6
Setup 87
For Example:
You want a specific cue list (cue list “x”) to appear as the last fader on every fader page.
In fader configuration, on each fader page assign one slider per page as a playback and
map it to 10.
When you load cue list x to fader 10, on any page that has a fader mapped to playback 10,
cue list x will be loaded to that fader.
Show Control
This section allows you to to adjust settings for MIDI show control and for time code (MIDI or
SMPTE) functions
{SMPTE Time Code}
This touchbutton is used to toggle SMPTE time code between “Enabled” and “Disabled”, thereby
controlling whether Eos can receive SMPTE time code. Choosing “Disabled” will disable all
timecode lists that have a SMPTE source. The default for this setting is “Enabled”.
{MIDI Time Code}
As above, but for MIDI instead of SMPTE. The default for this setting is “Enabled”.
{MSC Receive}
This touchbutton toggles the setting for receiving MIDI Show Control from an external source
between “Enabled” and “Disabled”. The default setting is “Disabled”.
{MSC Receive Channel}
Also known as “Device ID” this setting allows you to establish the device ID from which Eos will
receive MIDI show control information. Only MSC data with the correct device ID will be received.
A device ID can be from 0-126, or if set to 127 Eos will receive MSC data from all IDs (All Call). For
example:
• {MSC Receive Channel} [5] [0] [Enter]
{ACN - MIDI Receive Id(s)}
This setting allows you to specify the MIDI Show Control data that Eos will receive when transmitted
over the Advanced Control Network (ACN). When set, EOS will receive MSC data from any
gateway that has its “MIDI In Stream ID” set to the same number. ACN_MIDI Receive ID can be
from 1-32. ID ranges may be used. For example:
• {ACN_MIDI Receive ID} [2] [5] [Enter]
{MSC Transmit}
This touchbutton toggles the setting for transmitting MIDI Show Control from an external source
between “Enabled” and “Disabled”. The default setting is “Disabled”.
{MSC Transmit Channel}
Also know as “Device ID” this setting allows you to establish the device ID with which Eos will
transmit MIDI show control information. A device ID can be from 0-126. For example:
• {MSC Transmit Channel} [5] [0] [Enter]
N o t e : Specifying a {Mapped to} location does not specify the cue list that will be loaded
to that playback. Cue lists can be assigned to any playback. {Mapped to}
establishes the order in which faders will be loaded.
Whatever playbacks are mapped to “1”, they will auto-load with the first recorded
cue list. Whatever submasters are mapped to “1”, they will auto-load with the first
recorded submaster. Any playback mapped to 5 will auto-load with the fifth
recorded cue list, and so on.