ETC Eos v1.3 - Manual (Page 279)

24
Storing and Using Macros 265
Edit an Existing Macro
When you have created a macro using macro learn mode from live or otherwise, you can edit the
content of your macro by removing or adding commands and special macro softkey functions (such
as wait, loop, and so on).
From the macro editor display, select an existing macro number and press [Enter]. The selected
macro contents will display the detail section. Press {Edit} to make changes to the content.
When in edit mode, the browser changes to display all softkeys available for the system that would
otherwise be difficult to find when recording a macro.
Next to the softkeys display are paging buttons to page through the available softkeys. When used,
these paging buttons will not be stored as content in your macro.
In addition, a new set of macro editor softkeys are displayed while in edit mode including:
• {Loop Begin} - inserts a loop start command
• {Loop Num} - inserts an end command for a loop with a limited number of iterations. An
infinite loop is assigned when you use “0” for the iterations.
• {Wait} - inserts a pause
• {Delete} - removes commands from the macro
• {Cancel} - cancels edits made to the selected macro and returns you to the macro list
• {Done} - exits macro edit mode. You may also use the [Learn] key to enter and exit edit mode.
In edit mode, the cursor in the macro content detail section of the display provides use of the arrow
keys to navigate through the existing content list. Use of the arrow keys will not be stored to the
macro content.
To add content, place the cursor in the section that you want to insert, then add the command. To
delete a command, place the cursor ahead of the content to be deleted, then press the {Delete}
softkey.
Press [Select] when you have completed all editing. Press [Escape] to abort.