ETC Eos v1.3 - Manual (Page 102)

88 Eos Operations Manual
{ACN - MIDI Transmit ID}
This setting allows you to specify the ID number of MIDI Show Control data that Eos transmits over
an Advanced Control Network (ACN). When set, EOS will transmit MSC data to any gateway that
has its “MIDI Out Stream ID” set to the same number. ACN_MIDI Transmit ID can be from 1-32. ID
ranges may be used.
• {ACN_MIDI Transmit ID} [2] [5] [Enter]
Desk
This setup softkey accesses settings for the specific Eos device. Changing these settings does not
impact other Eos controllers on the Eos network. Two setting buttons are available in desk settings:
{Record Defaults} and {Manual Control}.
{Record Defaults}
This screen enables you to change general record defaults as well as change the default parameter
category times associated with certain actions ([Back], [Go to Cue], and [Assert]).
To change the setting for any of these fields, press the field in the CIA to activate it. If the field
requires data, enter it from the keypad. If the field is a toggle state, one press of the button will
switch the field to its other state.
Auto Playback
When enabled, this feature automatically plays back cues as they are stored and releases manual
control. This field is a toggle state between enabled and disabled. When auto playback is disabled,
all manual levels are maintained and cues must be loaded and executed on playbacks. The default
is “Enabled”.
Track
This field allows you to switch between tracking and cue only modes (see
Tracking vs. Cue Only,
page 5 ). The default is “Tracking”.
Record Confirm
This setting allows you to enable/disable the confirm action when storing over a previously
recorded target. The default is “Enabled”.
Auto Save
This setting enables of disables autosave functions. When enabled, Eos will automatically save the
show file based on the auto save interval (see below). When disabled, show files must be stored
from the browser. The default is “Disabled”.
N o t e : Filter setup, Encoder configuration, and Partition Configuration settings will all be
available in a future release.