ETC Eos v1.3 - Manual (Page 203)

14
Using Filters 189
Playback Filters
This feature will be available in a future release.
Filters can also be applied to the playback faders, therefore allowing only the filtered categories/
parameters to be played back on that fader.
Filtered parameter categories are selected in the same manner as record filters, in the CIA. Filters
are applied to playback faders by pressing [Playback Filter] and [Load] for the required fader. This
action takes the current settings of the filters and applies them to the fader.
To add filters to a playback fader:
Step 1: Press and hold [Filter].
Step 2: Select filters by pressing the direct select for the desired parameter category in the
CIA. Selected parameters will highlight and “Filter On” will appear beneath the
associated parameter category.
Step 3: Press [Playback Filter] & [Load] for the associated fader that you wish to assign the
filters to. The filters are now active on that playback fader.
To remove filters from a playback fader:
Step 1: Press [Playback Filter] & [Load] for the fader you wish to remove the filters from.