ETC Eos v1.3 - Manual (Page 218)

204 Eos Operations Manual
Using [Copy To]
[Copy To] allows you to copy data from one channel to another, either within the current working
mode or to a different record target. [Copy To] works much like [Recall From], but in the opposite
direction, [Copy To] forces data to a channel from the selected channel, whereas [Recall From]
pulls it from a channel to the selected channel.
You may copy all parameter data for selected channels, or by using the IFCB category buttons or
parameter buttons, you may copy subsets of channel data. Entire cues, cue ranges and cue lists
can be copied to other locations.
When copying information at a channel level, discrete timing is not included unless specified. When
copying entire cue(s), all timing data is copied. When referenced data is copied, if the copy target
also has data in the reference that is being copied, the target will be placed in that reference (such
as, CP 1), at its stored values. If the copy target is not included in the reference, absolute data will
be copied to the target, and not the reference.
Below are some examples of copy commands from record targets. This command is very versatile
and the following list is far from exhaustive:
• [2] [Copy To] [Cue] [5] [Enter] - copies all information for channel 2 to cue 5. Any discrete
timing data is not copied.
• [2] [+] [Time] [Copy To] [Cue] [5] [Enter] - As above, but timing data is included.
• [2] [Time] [Copy To] [Cue] [5] [Enter] - Copies just the timing data for all parameters of
channel 2 to cue 5.
• [2] [-] [Focus] [8Copy To] [Cue] [5] [Enter] - Copies all parameter data for channel 2, other
than focus, to cue 5.
• [Group] [3] [Copy To] [Preset] [6] [Enter] - copies current information for group 3 to preset 6.
• [3] Copy to] [6] [Cue] [y] [Enter] - copies the data from channel 3 to channel 6 in cue 8.
• [3] [Copy to] [4] [thru] [9] [Enter] - copies the data from channel 3 to channels 4 thru 9.
• [3] [Copy to] [8] [Cue] [2] [/] [1] [Cue Only/Track] [Enter] - copies the data from channel 3
to channel 8 in cue 2/1 and takes exception to the track/cue only settings in regard to
subsequent cues in cue list 2.
• [Cue] [2] [/] [Copy to] [Cue] [7] [/] [Enter] - copies all of the contents of cue list 2 to cue list 7.
• [Cue] [1] [/] [1] [thru] [1] [0] [Copy To] [Cue] [5] [/] [5] <thru> [Enter] - copies cues 1 thru
10 from cue list 1 to cue list 5, starting with cue 5.