Setting intensity – ETC Eos v1.3 User Manual

Page 114

Advertising
background image

100

Eos Operations Manual

Setting Intensity

Channel intensity may be manually entered from the keypad, set with an intensity palette (if
programmed) or set with the level wheel. Pressing [At] after channel selection assumes an
intensity value will be added to the selected channels. You may also use the [Full] button to bring
the selected channels to their full intensity or you may use the [Out] button to fade the intensity out.

Use the [Level], [+%] and [-%] keys to affect the intensity value of selected channels. Each of these
keys are set at a specific value established in the Setup (

{Manual Control}, page 90

).

• [Level] is set by default to full (100% intensity).

• [+%] and [-%] are each set by default value of 10 points.

The following examples illustrate the various methods of setting intensity:

[1] [+] [3] [At] [5] <0> [Enter] - selects channels 1 and 3, and sets an intensity level of 50%.

[1] [thru] [5] [-] [4] [Full] [Enter] - selects a range of channels 1 through 5, except channel

4, and sets the intensity to full.

[1] [thru] [8] [At] [+] [3] [Enter] - adds 30% to all intensities in the channel selection. If they

were at 50, they will now be at 80. If channels 1, 3 and 5, were at 30 and 4 was at 50, they
would be 60% and 80% intensity, respectively.

[5] [thru] [8] [At] [/] [3] [Enter] - scales the intensities of the selected channels in the list down

30% of their current values.

[1] [thru] [4] [At] [/] [1] [3] [0] [Enter] - scales the intensities of the selected channels in the

list up 30% of their current values. If channels 1 through 4 were at 40% intensity, this would
scale them up by 30% to a value of 52.

[2] [+] [5] [level wheel] - roll the wheel up for greater intensity or down for less intensity.

[1] [Level] - selects channel 1 and sets it to the level as established in Setup.

[Group] [9] [Out] - selects all channels in Group 9 and sets the intensity values for those

channels to zero. The exception would be if any channels in Group 9 were parked or captured.

Advertising