ETC Eos v1.3 User Manual
Page 103
6
Setup
89
System Blocks
This setting enables/disables system-applied blocks. When enabled, if a channel level is changed
to match the channel level in a succeeding cue, Eos will apply a block to the channel levels in the
succeeding cue, thereby preserving the initial concept of a move instruction for that parameter (see
When disabled, the value in the subsequent cue will be changed to be a tracked value and the
move instruction will be removed. The default is “Enabled”.
Delete Confirm
This field allows you to enable/disable a required confirmation before any delete command is
executed. The default is “Enabled”.
Auto Save Interval
This setting defines the frequency of auto saves (when they are enabled). Time can be entered in
seconds (30) or minutes and seconds (10:30). Use the keypad to enter times and verify in the
command line that the timing value appears as you intended.
Back Time, Go To Cue Time, Assert Time
Each of these features allow you to change the respective feature response times based upon
parameter category. Each parameter category (Intensity Up, Intensity Down, Focus, Color, and
Beam) may have a specific time for each feature. The default for all times in these features and
categories is 5 seconds.
You can change all of these times by selecting the first available and pressing [Thru] followed by a
number of seconds and then [Enter].