Lenze c300 - Manual (Page 34)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
34
5 Commissioning the controller
5.4 Configuring the controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.4.2.1 Cabinet controllers with external monitor panels (3231 C/3241 C)

Tip!
Connect a keyboard to the Controller to be able to enter the IP address.
Then you can make the entries:
[5-1] IP settings of the controller by default
• Start the control panel with <Shift+F4>.
• Start the network connections by double-click and enter the IP address, subnet mask, and the
default gateway.
• After clicking the button the IP address is saved and need not be entered again when the
system is restarted.

Note!
If an external display (monitor panel) is used, the switch-on sequence of display/
controller must be observed so that it can be correctly controlled by the controller:
• Connect the external display to the DVI output of the controller and switch it on
before switching on the controller.
After connection of a monitor panel/an external display to a running controller, the
display resolution is VGA .
• Calibrate the monitor panel/ display connected, so that the screen content can be
displayed correctly.