Lenze c300 - Manual (Page 111)

12 Visualisation with »VisiWinNET®«
12.5 Using the LogicAndMotionV3 direct driver (remote access)
111
Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.5 Using the LogicAndMotionV3 direct driver (remote access)
Select the target device (Windows® XP operating system)
Using the direct driver for LogicAndMotionV3.x under »VisiWinNET® Smart«.

How to use the direct driver:
1. Select new project with the desired target device, example: Controller 3241C.
For cabinet controllers: select connected monitor panel.
2. For the configuration of the LogicAndMotionV3 channel, the address of the target device
(Controller - control PC) must be specified.
3. The further procedure is identical to steps 2 to 5 of the LogicAndMotionV3 direct driver
under Windows® CE:
 Selecting the target device using the Windows® CE operating system (example 3200 C/
p500) ( 102)