Lenze c300 - Manual (Page 46)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
46
6 Parameter setting using »WebConfig«
6.3 Online connection from the Engineering PC to the controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3 Online connection from the Engineering PC to the controller
Connect the Engineering PC to the Controller using a network cable or connect the Controller to the
network which is accessed to the Engineering PC.
6.3.1 Setting IP addresses on the Engineering PC (example: Windows® XP)
Setting for the direct connection between Engineering PC and controller:

How to set the static IP address of the Engineering PC:
1. Open the Network connections dialog box.
StartSettingsNetwork connections
2. Select the network interface which is connected to the Controller.
Right-click Properties.
3. Select Internet protocol (TCP/IP).
4. Click the Properties button.
5. Select the Alternate configuration tab.
6. Select the User configured option.
• Enter the IP address. The subnet range of this IP address and the one of the IP address of
the controller must be the same, example: <192.168.5.100> (Lenze setting of the
controller: <192.168.5.99>).
• Enter the subnet mask of the Engineering PC (standard setting: <255.255.255.0>)
7. Close the individual dialog boxes with OK/Close.

Note!
In the case of a direct connection between the Engineering PC and the controller, a
crossed network cable is required.
The settings of the static IP address of the Engineering PC are only to be carried out for
the direct connection between the Engineering PC and controller.

Note!
Recommended setting for the Engineering PC:
IP address: <192.168.5.100>
Default settings of the controller:
IP address: <192.168.5.99>, subnetwork <255.255.255.0>.