Rockwell Automation 1771-PM , D17716.5.18 U MNL 1771-PM CLUTCH/BRAKE MOD - Manual (Page 22)

Clutch/Brake Controller Hardware
Chapter 3
3Ć13
Figure 3.6
Module Locations
Required 1771 -IA modules for
press inputs chassis A & B
module group 0, slots 0 & 1
module group 1, slot 1
module group 2, slots 0 & 1
Optional 1771 -OA modules for display of
message codes, brake fault, run window and micro inch.
module group 3, slot 1 chassis A
module group 5, slot 1, chassis A & B
Optional 1771 -IA modules for micro-inch inputs, chassis A & B
mdoule group 5, slot 0
1771 -PM
module
Optional 1771 -IA modules for station 3 & 4
inputs chassis A & B (remove them if you do
not configure for stations 3 & 4
module group 1, slot 0
These slots must remain empty in chassis A & B
module group 6, slots 0 & 1
module group 7, slots 0 & 1
Required 1771 -OD modules for outputs
to solenoid valves, Chassis A & B
module group 3, slot 0
Optional micro -inch indicator, chassis B
1771 -OA, module group 3, slot 1
Optional modules for dump
valve in chassis A & B
1771 -OD, module group 4, slot 0
1771 -IA, module group 4, slot 1
Chassis A
1771 -A4, -A4B
1771 -PM
module
Chassis A
1771 -A4, -A4B
12247
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7
Important: Use 1771ĆA2, ĆA2B chassis when not using optional dump valves,
display of diagnostic message codes, nor microĆinch inputs.