Rockwell Automation 1771-PM , D17716.5.18 U MNL 1771-PM CLUTCH/BRAKE MOD User Manual
Page 45
Advertising
Voting Processor Firmware
Chapter 5
5Ć6
Single Stroke Mode
Use single-stroke mode to actuate the press through a single cycle.
During the downstroke (Figure 5.3)
releasing a RUN button stops the press
if the shaft did not enter the near bottom zone, you may resume the
downstroke
if the shaft entered the near bottom zone, you must inch the press back
to the near top position before restarting
During the upstroke (Figure 5.4)
the shaft continues automatically through the upstroke
If you enabled on-the-hop , you can start another cycle without stopping
the press if you
release all RUN buttons after the near bottom position
press all RUN buttons after the anti-repeat contacts open during the
upstroke
Advertising