Canon REALiS X600 - Manual (Page 128)

User Command Specifications 9．Details of command GET SIGNALSTATUS
1 GET SIGNALSTATUS
GET SIGNALSTATUS
GET□SIGNALSTATUS
?△SIGNALSTATUS
g:SIGNALSTATUS=<Signal status：ＩＤ>
NO_SIGNAL Signal not detected
DISPLAYING Image now displayed or display enable status
SETTING
Signal detection and display preparation in progress
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（
Refer to the ZCONTDRV command and FCONTDRV command.）
For the "SX50," the remote mode must be established.
-2 This returns the signal status of the selected input. Use INPUT command for the input selection.
-3 Even if the status is "DISPLAYING" (image now shown), the image is not displayed during blanking.
Check the status using GET BLANK. To clear the blank status, use BLANK=OFF.
-4 Similarly, the image is not displayed during "no show".
Check the status using GET NOSHOWSTATUS.
To clear no show, execute RC NOSHOW.
> GET SIGNALSTATUS or ? SIGNALSTATUS
< g:SIGNALSTATUS=NO_SIGNAL
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
SX60
○
01.01**
Meaning
○
X600
This inquiry can be made at any time provided that the power-on status is established.
Reference Setting
Function
Format
Signal status inquiry
This inquires about the current image signal input status.
ID
Signal status
Description
Mode
Remote Local
Commands Mode Control
Response
D-Video
01.01**
A-RGB2 Comp Video S-Video
Remarks
SCART None
SX50 ○ ○ ○
Model Power Input
○ × ○ ○ ○ – – ○
○ ○ ○ ○ ○ ○ ○ ○ ○
X600
SX60
Example
Commands
supported
SX6 ○ ○
D-RGB A-RGB1
○ ○
SX50
01.00** 01.01**
SX6
PAGE 120