Canon REALiS X600 - Manual (Page 144)

User Command Specifications ９．Details of command RANGE SEL
1 RANGE SEL
RANGE SEL
RANGE□SEL
r:SEL=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE SEL
< r:SEL=I, AUTO
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
SX6
Setting Reference
Commands
supported
For all other responses, refer to "Error List."
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
The input signals can be selected by the SEL command.
This inquires about the parameter options which enable the input signals to be set.
SX60 X600
○ ○ ○ –
ID
Commands
Function
Format
Input signal setting option request
Mode Control
Example
Description
Response
01.00**
SX50
01.01** 01.01** 01.01**
○ ○ ○ ○
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 Ч Ч Ч – Ч ○ Ч
SX6 Ч Ч Ч Ч ○ ○ ○ Ч Ч Ч ○
X600
SX60
PAGE 136