Canon REALiS X600 - Manual (Page 25)

User Command Specifications 9.Details of command AUTOＳＥＴEXE
1 AUTOＳＥＴEXE
AUTOＳＥＴEXE
AUTOSETEXE□<Auto set parameter：ＩＤ>
Auto set parameters
For details, refer to the RANGE command .
“i:OK” is returned when the automatic processing was completed successfully.
One of the following responses is returned if an error has been detected at any part of the auto setup.
Type Error response
FOCUS e:F002 SYSTEM (FOCUS)
VKS e:F004 SYSTEM (AUTO_KEYSTONE)
SCRN e:F005 SYSTEM (SCREEN_COLOR)
For all other responses, refer to "Error List."
(1)
However, a "busy" response is given while the zoom or focus lens is being driven.
（ Refer to the ZCONTDRV command and FCONTDRV command . ）
(2)
(3)
Type Remarks
FOCUS
VKS －
SCRN
INPUT
(4)
Setting
> AUTOSETEXE FOCUS Auto focusing is executed.
< I:OK
Acquisition of parameters which can be set
> RANGE AUTOSETEXE
<
r: AUTOSETEXE=I, FOCUS, VKS, SCRN, INPUT
*Commands are indicated by ">", and responses are indicated by "<".
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
OFF ON PM
Ч ○ Ч
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Commands
supported
Statuses in which auto setup
cannot be executed
Auto setup cannot be executed
while "BLANK" is underway.
Refer to the BLANK
command.
Auto setup cannot be executed
while "BLANK" is underway. Refer to the BLANK
command.
Example
SX50
０１．０１**
Parameter
Auto keystone (vertical) execution
Automatic screen color correction
execution
Meaning
FOCUS Auto focusing
It is not possible to execute auto setup in some projector statuses.
There are no parameters to be executed together. Execute them separately.
SX60 X600
Auto setup cannot be executed
if there are no input signals.
Commands
Function
Parameter
Setting Control Mode
ＩＤ
Auto setup
Automatic signal sensing execution
Reference
Description
VKS
SCRN
INPUT
The parameters which can be controlled at any given point in time can be obtained using the
RANGE command.
This command is used to execute auto setup.
Response
It can be executed when the projector is in both the remote mode and power-on status at the same
time.
SX6
０１．００** ０１．０１** ０１．０１**
When automatic screen color correction (SCRN) has been completed successfully, the screen color
correction (WB) is set to "ADJUST."
× ○ ○ ○
Model Power supply Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 － － －
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
Format
X600
PAGE 17