Canon REALiS X600 - Manual (Page 27)

User Command Specifications 9. Details of command INPUT
1 INPUT
INPUT
INPUT=<Input selection parameters：ＩＤ>
Input selection parameters
"i:OK" is returned if the parameter was set properly.
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2 This command has the same function as the buttons listed in the table below.
Button
「
Computer-1」、「〃-2」、「VIDEO/S」
INPUT
-3
-4
-5
Example Setting
> INPUT=VIDEO VIDEO input selection
< i:OK
Reference
> GET INPUT or ?INPUT This retrives the input signal
< g:INPUT=A-RGB1
Acquisition of parameters which can be set
> RANGE INPUT
< r:INPUT=I, D-RGB, A-RGB1, A-RGB2, COMP, VIDEO, S-VIDEO, D-VIDEO, SCARTRGB
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
Commands
supported
Refer to the AUTOSETEXE command.
Description
SX50
○
01.00**
○
○
○
○
○
○
○
○
○
○
Parameter
Video
D-VIDEO Digital Video
D-RGB
S-Video
D-RGB
A-RGB1 A-RGB1
A-RGB2
COMP
S-VIDEO
Response
This controls the input selection.
Component
ID
VIDEO
Parameter Meaning
○
Commands
Function Input selection
Mode Control Setting Reference
○
Ч
○
Ч
○
○
○
A-RGB2
SX60 X600
Errors supported by model
SX50 SX6 SX60 X600
○
○
○
○
○
○
○
○
○
Model
SCARTRGB SCART(RGB) ○
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
For details, refer to the GET command.
The current input can be acquired using the applicable GET command.
SX50
SX6
When the model SX6, SX60 or X600 is used, the input can be selected automatically using the
auto setup command (AUTOSETEXE=INPUT).
○
○
○
○
SX6
○ ○
01.01** 01.01** 01.01**
○
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
Format
X600
When the model SX50 is used, "A-RGB2" and "COMP" cannot be selected if "OUT" has been
set using the TERMINAL command. ('e:1001 TERMINAL_OUT' is returned.)
SX60
X600
(Refer to the ZCONTDRV command and FCONTDRV command.)
PAGE 19