Canon REALiS X600 - Manual (Page 89)

User Command Specifications 9．Details of command GET SEL
1 GET SEL
GET SEL
GET□SEL
?△SEL
g:SEL=<Input signal: ID>
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2 The input signals can be selected by the SEL command.
> GET SEL or ? SEL
< g:SEL=575p
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Remarks
ID
480i 240p (NTSC system non-interlaced signals) included
UNKNOWN No-color, 1080p, and other signals
480p
PAL-M,PAL-N included
575p
NTSC NTSC4.43 included
1080i 540p (1080i non-interlaced signals) included
720p
1035i
X600
SX60
Ч Ч ○ Ч ○ ○ ○ Ч SX6 Ч Ч Ч
– Ч ○ Ч SX50 Ч Ч Ч
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Model Power Input Mode
Remote Local
○ ○ ○
Commands
Function
Format
Description
Response
○ ○ ○ –
Commands
supported
Example
X600 SX50 SX6
01.00** 01.01** 01.01** 01.01**
○
Reference
Input signal inquiry
Input signal
PAL
SECAM
SX60
288p (PAL system non-interlaced signals) included
Mode Control
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
This inquires about the current input signals.
575i
Setting
PAGE 81