Canon REALiS X600 - Manual (Page 183)

User Command Specifications ９．Details of command RANGE FSTEPDRV
1 RANGE FSTEPDRV
RANGE FSTEPDRV
RANGE□FSTEPDRV
r:FSTEPDRV=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
For all other responses, refer to "Error List."
This command is used to inquire about the parameter options which enable the step drive of the focus lens.
(1)
However, a "busy" response is given if the zoom or focus lens is being driven .
（ Refer to the ZCONTDRV command and FCONTDRV command. ）
(2) Step control for the focus lens can be exercised using the FSTEPDRV command .
> RANGE FSTEPDRV
< r:FSTEPDRV=I, FAR, NEAR
When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Supported Command States
OFF ON PM
－ － －
Ч ○ Ч
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Commands
supported
X600
SX60
○ ○ ○ × ○ ○ ○ ○ SX6 ○ ○ ○
－ － － － － － － － SX50 － － －
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Model Power supply Input Mode
Remote Local
× ○ ○ ○
SX6 SX60 X600
０１．００** ０１．０１** ０１．０１** ０１．０１**
SX50
Commands
Function
Response
Description
Format
Control Setting Reference Mode
Example
Focus lens step drive control option request
ＩＤ
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
PAGE 175