Canon REALiS X600 - Manual (Page 181)

User Command Specifications ９．Details of command RANGE ZSTEPDRV
1 RANGE ZSTEPDRV
RANGE ZSTEPDRV
RANGE□ZSTEPDRV
r:ZSTEPDRV=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
For all other responses, refer to "Error List."
This command is used to inquire about the parameter options which enable the step drive of the zoom lens.
(1)
However, a "busy" response is given if the zoom or focus lens is being driven .
（ Refer to the ZCONTDRV command and FCONTDRV command. ）
(2) Step control for the zoom lens can be exercised using the ZSTEPDRV command .
> RANGE ZSTEPDRV
< r:ZSTEPDRV=I, WIDE, TELE
When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Supported Command States
OFF ON PM
－ － －
Ч ○ Ч
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting Reference Mode Control
Commands
supported
Example
Zoom lens step drive control option request
ＩＤ
This inquiry can be mades when the projector is in both the remote mode and power-on status at
the same time.
０１．００**
Commands
Function
Response
Description
Format
SX50
○ ○
SX6 SX60 X600
０１．０１** ０１．０１** ０１．０１**
Model Power supply Input Mode
Remote Local
× ○
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 － － － － － － － － － － －
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
X600
PAGE 173