Canon REALiS X600 - Manual (Page 35)

User Command Specifications 9. Details of command IMAGE
2 IMAGE
IMAGE
IMAGE=<Image mode setting parameter：ＩＤ>
Image mode setting parameters
This sets the image quality.
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
-3
Menu
[Image adjustments] - [Image mode settings]
[Image adjustments] - [Image mode settings]
-4
Brightness BRI
Contrast CONT
Sharpness SHARP
Gamma adjustment GAMMA
Dynamic gamma DGAMMA
Progressive PROG
WB/ WBRGB
For the SX50
Saturation/hue SAT/ HUE
Advanced color adjustment ACADJUST For the SX50
Memory color correction MEMCADJ For the SX6, SX60 or X600
RGB gain/offset adjustments RGBGAIN/RGBOFFSET For the SX6, SX60 or X600
6-axis color adjust 6AXR～Y
-5
Setting
> IMAGE=PRESENTATION This sets the image mode to "Presentation."
< i:OK
Reference
> GET IMAGE or ?IMAGE This references the current image mode.
< g:IMAGE=CINEMA
Acquisition of parameters which can be set
> RANGE IMAG
< r:IMAGE=I, STANDARD, CINEMA, SRGB
* Commands are indicated by ">", and responses are indicated by "<".
○
○
Ч
○
Ч ○
SX6
01.01**
Movie
Ч
Ч
Home theater
Movie & Photo
×
Changing the setting may modify the following setting values.
The current image quality can be acquired using the applicable GET command.
SX60
X600
SX60 SX50 SX6
01.00**
For details, refer to the GET command.
Model
SX50
PRESENTATION
CINEMA
MOVIE_PHOTO
SRGB
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
This command is the same as the menu functions in the table below.
×
Errors supported by model
SX50 SX6 SX60 X600
Example
Description
Response
ADOBE
HOME_CINEMA
MOVIE
"i:OK" is returned if the parameter was set properly.
ADOBE RGB
The final settings for the image mode are retained even when the power is turned off.
×
○ ○
Cinema ○ ×
Commands
Function
Parameter
Standard
Image mode setting
○ ○ STANDARD
Parameter Meaning
X600
ID
○
"STANDARD," "CINEMA" or "SRGB" can be set as
the image mode.
○
×
Presentation
sRGB
○
01.01** 01.01**
Format
○
Ч Ч
○
Ч
Ч
○
○
Reference
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
Mode Control Setting
○
○
×
Commands
supported
Screen color correction/RGB
adjustment values
Commands related to the
settings
Remarks Setting
○ ○ ○ ○
PAGE 27