Canon REALiS X600 - Manual (Page 39)

User Command Specifications 9. Details of command SHARP
1 SHARP
SHARP
SHARP=<Sharpness setting: Number>
Sharpness setting (-4 to 4)
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Image adjustments] - [Sharpness]
[Image adjustments] - [Sharpness]
-3
-4
Setting
> SHARP=3 This sets the contrast to 3.
< i:OK
Reference
> GET SHARP or ?SHARP This retrieves the contrast.
< g:SHARP=3
Obtain settable parameter range (Min, Max)
> RANGE SHARP
< r:SHARP=N, -4, 4
Any value from -4 to 4 can be set for the sharpness.
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
The RANGE command can be used to obtain the parameter range that can be set at
that time.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
SX50
SX6
01.01**
"i:OK" is returned if the parameter was set properly.
Local SCART None
Model Power Input
Example
SX50 SX6 SX60 X600
Commands
Function
Parameter
Description
Response
Format
Mode
This sets the screen sharpness.
Model
Control Setting Reference
For details, refer to the RANGE command.
Number
Sharpness setting
For all other responses, refer to "Error List."
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
Mode
Remote
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ × ○ ○ ○ ○ ○ ○ ○
SX60
X600
This command is the same as the menu functions in the table below.
This sets the currently selected input signal and image mode.
The current sharpness can be acquired using the applicable GET command.
SX60
X600
○
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
Commands
supported
○ ○ ○
01.00** 01.01** 01.01**
PAGE 31