ThingMagic M5e-Compact - Manual (Page 135)

Application Tag Commands
Command Set 135
Change EAS (1 byte: 0x01=Set EAS; 0x02=Reset EAS)
It is invoked with the following command:
The response to the ChangeEAS command is a simple ACK with standard status:
ChangeEAS embedded in a Read Tag Multiple take the following form:
EAS Alarm
The NXP command EAS Alarm causes the tag to return coded information, but only when
the tag has its EAS system bit set. This command requires several fields in addition to the
common fields
Divide Ratio as Per Gen2 (DR) (1 byte: Current fixed to 0x01, M5e and M5e-C only
support DR=64/3)
Miller Cycles (M) (1 byte: 0x01, M=2; 0x02, M=4;or 0x03, M=8)
Note: This value of M must be the same as the value set in Set Protocol Configuration (9Bh) .
FF 11 2D 03 E8 02 44 00 03 00 00 00 78 08 34 11 22 33 44 01 ?? ??
SOH Length OpCode Timeout (ms) Chip
Type
Option Sub
Cmd
Select Data Address Select
Length Selct
Data Access Password EAS CRC
FF 04 2D 00 00 02 44 00 03 ?? ??
SOH Length OpCode Status Chip
Type
Option Sub
Cmd
CRC
FF 1C 22 04 00 04 03 E8 11 22 33 44 00 00 00 78 08 34
SOH Length OpCode Options
(EPC Mem)
Search
Flags
Timeout Access Password Select Data Address
(bits)
Select
Data
Length
(bits) Select
Data
01 0B 2D 00 00 02 40 00 01 11 22 33 44 01 ?? ??
Embd
Cmd
Count Embd
Cmd
Length Embd
Cmd
OpCode Embd Cmd
Timeout
(Not Used)
Chip
Type Option Sub Cmd Access Password) EAS CRC