ThingMagic M5e-Compact - Manual (Page 162)

Set Application Commands
162 Command Set
Note
Setting the parameters using Set User Mode will override the values set by
a previous call to
Set Protocol Configuration (9Bh) .
Note
For details on the behavior of the Gen2 parameter settings see the
EPCGlobal Gen2 RFID Air Interface Specification v1.2.0 or later.
Set Reader Configuration(9Ah)
The Set Reader Configuration command is used to set several configuration options on
the reader. The Option byte indicates whether to use the new key/value pair setting or the
previous, bitwise, settings. One example configuration and the corresponding Options
value is specified in the command example below. For other combinations the hex value
for Options will need to be calculated by OR’ing the bits for each setting.