ThingMagic M5e-Compact - Manual (Page 180)

Get Application Commands
180 Command Set
Available power modes
Note
Maximum Saving Mode only supports communications at 9600 baud
The command gets the current power mode setting from the module:
The example reply shows that the system is in the medium power saving mode:
Get User Mode (69h)
The Get User Mode command returns the type of application in which the M5e/M5e-
Compact can be used. The list of user modes and their corresponding protocol
configuration settings can be found in
Available Gen2 User Modes .
The command gets the current user mode setting from the module:
The example reply shows the current user mode setting:
Hex Power Mode
0x00 Full power mode
0x01 Minimal saving mode.
0x02 Medium saving mode.
0x03 Maximum saving mode.
0x04-0xFF Reserved for future use.
FF 00 68 1D 67
SOH Length OpCode CRC
FF 01 68 00 00 02 A4 BD
SOH Length OpCode Status Power Mode CRC
FF 00 69 1D 66
SOH Length OpCode CRC