Talkswitch 24-CA - Manual (Page 101)

T A L K S W I T C H C O N F I G U R A T I O N 8 9
2.4.4 VoIP Numbers
This section deals with how VoIP-enabled units handle incoming VoIP calls.
For information on VoIP-enabled numbers, please refer to Chapter 5: VoIP
Information on page 155.
1. Select a VoIP number to configure.
2. Select the mode for which you want TalkSwitch to use these settings.
If you entered the phone number in System Information ->
VoIP Numbers, the number will display on the corresponding button.
Figure 89: VoIP numbers
Descriptions for VoIP numbers and telephone lines on the features below are
the same.
Ring extensions only (no auto attendant is played),
Play auto attendant or Go to voice mailbox and
Adjust Sequence... (button)
This section controls how the extensions will ring before the auto attendant
answers the call.
• If you have chosen the auto attendant to answer calls immediately, this
section does not require configuration and is grayed out.
• If the auto attendant is set to answer after 1 or more rings, configure
when specific extensions ring before the auto attendant answers.
• If no auto attendant is selected to answer on the specified line, specify
when particular extensions will ring up to 9 times. Remember that no
calls go to voicemail unless you first have an auto attendant answer.