Talkswitch 24-CA - Manual (Page 76)

6 4 T A L K S W I T C H US E R G U I D E • N O R T H A M E R I C A
Figure 61: Music port
You can use separate audio sources for each unit.
2. Once the audio source(s) is (are) connected to TalkSwitch,
turn it (them) on.
3. Connect the unit to your computer and open your configuration
software.
4. Select System Information -> On-Hold/Ringback.
5. In the On-Hold Settings, select Play music whose source is connected to the
MUSIC jack. See Figure 62.
6. Save settings to the unit.
Figure 62: Music on hold
If you have more than one unit connected to the LAN and you are using an
external music source, you need to connect the source to all units. Use a
1/8" audio splitter, available at most electronics stores. If you are using a
.wav file loaded on the unit, the music file is copied to all units on the
LAN.