Talkswitch 24-CA - Manual (Page 55)

T A L K S W I T C H C O N F I G U R A T I O N 4 3
and by call bridge. Each hunt group can support several line choices and
attempt to use an available line in the order that they are listed for that
hunt group. These settings have no effect on incoming calls.
Default setup:
1. Select System Information -> Line Hunt Groups.
2. Select a Line Hunt Group and enter a unique Line Hunt Group name to
identify this group elsewhere in the configuration software.
3. Under Set Line Hunt Group, select the Line Type. If you wish to use this
hunt group to access telephone lines, select Phone Lines. To use this hunt
group to access VoIP numbers, select VoIP numbers.
4. Click the checkbox(es) next to the line(s) you wish to add to the hunt
group.
Figure 41: Hunt group configuration
Hunt Group 9: selects any available telephone line.
Hunt Group 81: selects telephone Line 1.
Hunt Group 82: selects telephone Line 2.
Hunt Group 83: selects telephone Line 3 (only four-line models).
Hunt Group 84: selects telephone Line 4 (only four-line models).
Hunt Group 88: selects any available VoIP number (only applies
when a VoIP unit is present on the LAN).
If multiple units are connected to the LAN, outbound calls always hunt
the lines on the unit where the extension is connected. This minimizes
network traffic between units.