Talkswitch 24-CA - Manual (Page 47)

T A L K S W I T C H C O N F I G U R A T I O N 3 5
2.2 SYSTEM INFORMATION
2.2.1 Administration
For security reasons, we recommend that you use password protection at the
administrator level. The password is entered at configuration start-up and
when you access the configuration through an extension phone.
To activate the use of a system password:
1. Click the next to System Information -> Administration.
Figure 33: Username and password
2. If you have units in different locations, we recommend that you assign a
system name to each unit for tracking purposes. Enter a name in the
System Name field. The system name will also be required when you are
logging in through the web interface of the unit for status or Call Detail
Record (CDR) information. For more information, see
Chapter 4: Call Detail Record (CDR) Logging on page 147.
Public Address (PA) Each unit has a PA output for connection to a
public address system. The PA output for a
TalkSwitch unit is only accessible from extensions
connected to that unit. To connect all outputs to a
single amplifier, you will require an adapter.
Some of the configuration screens that follow may vary depending on
whether the unit is networked or not. In most cases, the 48-CA/CVA
screen is shown unless the caption indicates a 24-CA screen. The 24-CA
models do not have IP Configuration and VoIP Configuration in the
System Information folder.