Talkswitch 24-CA - Manual (Page 82)

7 0 T A L K S W I T C H US E R G U I D E • N O R T H A M E R I C A
This option is useful for cell phones where the cell phone company plays a
“subscriber not available” message instead of a busy tone. Once the cell
phone is answered, TalkSwitch prompts you to respond to the incoming
voicemail with
or .
1. Click the checkbox next to Pager if you want to be notified by pager
when new messages arrive.
2. Enter the pager number as you would normally dial it from your
TalkSwitch location.
3. Enter the numeric message to be displayed on the pager.
Configure Notification Options (button)
Define how TalkSwitch dials out of your office when notifying you of a
voicemail. If the first connection is not successful, determine the number of
times TalkSwitch continues to attempt the connection.
When you choose to be notified by pager and remote phone, TalkSwitch
ensures that both locations have been contacted before finishing the
notification process.
Figure 68: Configure notification options
Dial notification phone number using:
Select the hunt group you want to use for the remote phone and pager
notification calls. You can also adjust the number of rings before it aborts
the attempt and follows the parameters listed in the next section.
If attempt unsuccessful, try again:
These parameters control how many times TalkSwitch tries to notify the
remote phone or pager before it aborts the notification attempt. You can
specify the time interval between attempts.
* #