Talkswitch 24-CA - Manual (Page 185)

V O I P I N F O R M A T I O N 1 7 3
• For Play auto attendant, select which auto attendant to play (for
example, 1), the number of rings to take place before the auto attendant
answers (for example, after 2 rings), and the extensions to ring before
the auto attendant answers. If you want the auto attendant to answer all
calls immediately without ringing extensions, select immediately rather
than the number of rings.
• For Go to voice mailbox, select the mailbox number (for example, 111)
and the number of rings to occur before the call goes to the voice
mailbox.
5. Repeat Steps 3 and 4 for each mode.
Figure 135: Call handling
6. Repeat this process to configure the VoIP numbers 2-12.
7. For systems with multiple units, repeat the process for each TalkSwitch
unit (click on the tabs labeled TalkSwitch 1, TalkSwitch 2, TalkSwitch 3,
and TalkSwitch 4).
5.4.3.3 Assign service provider phone numbers
1. In the TalkSwitch System Configuration window, select
System Information ->VoIP Numbers.
2. Select 1 and check the Activate VoIP Number box, the default profile for
entering a phone number is the TalkSwitch Profile. Select Service Provider
Profile.
3. Enter one of the phone numbers, exactly as provided by your VoIP service
provider. If your service provider requires a country code, enter it,
otherwise leave it blank.