Talkswitch 24-CA - Manual (Page 209)

A P P E N D I X C 1 9 7
TalkSwitch settings and configurations
In the event of a power failure, your TalkSwitch settings and configurations
will not be lost.
The TalkSwitch configuration is stored in non-volatile memory. Non-volatile
memory means that your feature settings (configurations) remain in the
TalkSwitch memory despite interruptions in the power supply.
Calling features
In the event of a power failure, TalkSwitch features or capabilities,
including VoIP will be unavailable except for local extension 114. You can
make or receive calls on Line 1. When the power is restored, all TalkSwitch
features and capabilities will be re-established.
Mode scheduling and power interruptions
When the power supply to TalkSwitch has been interrupted, TalkSwitch’s
internal clock will continue to run for up to 12 hours. If you have enabled
the automatic mode scheduling feature and it has been longer than 12
hours, TalkSwitch will not function properly until the internal clock is reset
via a caller ID call or with the TalkSwitch configuration software. When
power is restored to TalkSwitch, it will check the time and determine the
mode it should be running according to the configuration and set itself to
that mode.
To check the current mode of operation:
1. Dial at a local extension to enter command mode and enter a
password if required.
2. Dial 30 . TalkSwitch will report the current mode.
#
#
A P P E N D I X C
A P PE N D I X C : TA L K S W I T CH A N D PO W E R I N T E RR U P T I O N S
TA L K SW I TCH A N D PO W E R
I N TE R R U P T I O N S